UCCNC - Software update or new version
34 posts
• Page 4 of 4 • 1, 2, 3, 4
Re: UCCNC - Software update or new version
by cncdrive » Sat Apr 05, 2025 10:44 am
Good catch. I updated that now to 1.2118
- cncdrive
- Site Admin
- Posts: 5183
- Joined: Tue Aug 12, 2014 11:17 pm
Re: UCCNC - Software update or new version
by El Ventu » Sun May 25, 2025 12:44 pm
Hello!
I just started testing my mill with the 1.2113 version, yesterday I tried to write a WHILE cycle as I'm used at work (I'm a lathe machinist on a Mori Seiki NL, Mitsubishi CNC FANUC based), but it didn't work.
Did I need to upgrade the software?
If yes, what release can be stable enough for a 3axis milling machine?
Thank you!
I just started testing my mill with the 1.2113 version, yesterday I tried to write a WHILE cycle as I'm used at work (I'm a lathe machinist on a Mori Seiki NL, Mitsubishi CNC FANUC based), but it didn't work.
Did I need to upgrade the software?
If yes, what release can be stable enough for a 3axis milling machine?
Thank you!
- El Ventu
- Posts: 27
- Joined: Wed Mar 06, 2024 8:44 am
Re: UCCNC - Software update or new version
by cncdrive » Sun May 25, 2025 4:18 pm
There is no stable release which supports that.
>1.2115 versions support while cycles.
>1.2115 versions support while cycles.
- cncdrive
- Site Admin
- Posts: 5183
- Joined: Tue Aug 12, 2014 11:17 pm
Re: UCCNC - Software update or new version
by El Ventu » Sun May 25, 2025 11:01 pm
cncdrive wrote:There is no stable release which supports that.
>1.2115 versions support while cycles.
Ok, thank you!
I'll wait for it to be stable!
Davide
- El Ventu
- Posts: 27
- Joined: Wed Mar 06, 2024 8:44 am
34 posts
• Page 4 of 4 • 1, 2, 3, 4
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 3 guests