I was using Mach 3 on one of my older machines today
The cut wasn't quite the right depth- so I used feedhold and set the z dro 0.4mm further down then continued
This can't be done in uccnc??
cncdrive wrote:
What do you guys think?
Battwell wrote:Correct re some machining has already been done- however it's nice to dial it all in before restarting from scratch every time - that just wastes too much time
In Mach I can leave spindle running etc and just set dro to correct depth which will be taken up on next commanded z move
It's just one of the little niceties I miss using uccnc ( ha ha but I won't go back to Mach 3)
Users browsing this forum: No registered users and 2 guests