Uccnc, AXBB-E and VFD

[pspyve]

Hi guys, just wanting to get some ideas on what I am doing wrong. I've connected all the wiring in the right places I think. But what is supposed to happen is when I change the speed of the spindle ( by typing s2500 in the MDI) this should change the voltage at AO1 (on the AXBB-E). However it doesn't. Whatever settings I change in uccnc it always remains the same (1.015v).
I've left the jumper on as it says printed onto the board that on is 10v and off is 5v

Axbb-e printed circuit board

Here is a screen shot of the spindle page settings.

Uccnc spindle page

I just am wanting to know what settings I need to change to get the AO1 terminal to read voltages between 0 and 10v.
Cheers
Phil

[ger21]

Do you have this set to channel 1?

Capture.JPG (5.44 KiB) Viewed 90 times

[pspyve]

Hi Gerry, thanks for replying. Yes, I have it set to 1.

Spindle PWM setting

Cheers
Phil