Ok I don't know if this the correct place to post this but here is goes.
I have been running some Gcode in my router to test the functionality of Uc100 and UCCNC software. I understand the issues mentioned can be caused from several things not just the motion controller and /or software.( more likely its operator error)
Item 1 The xbox plugin is useless in my opinion. Only the left stick works. I get no input from the right stick. I select the "show " button and look at the control leds to see what input is what then assign the function I want to it. Again the right stick does not work with this plugin.
Item2 I would like to use park but I need to tell the software where I want the machine to go I don't see any way o do this.
Item3 With no way to calibrate the spindle when a M3 is issued the rpm is wrong. I see this also in Mach3 using the Uc100.
Item4 The Gcode is executed correctly and the final result is really good.However When running the Gcode the movements are jerky. I played with the
Stop and angles > then setting
Look ahead line count
linear error max
linear addition length max
linear unify length max
corner error max
but nothing helped the jerky movement.
Any input on how to correct this would be greatly appreciated.
Charlie Moore