New Button Help

If you created a new screenset and want to share it with others then please post it here. You can talk about screens here.

New Button Help

Postby ADuarte » Thu Aug 12, 2021 2:30 pm

Hello all. I have a customer that wants a macro(s) on screen as a button to turn a clamp on and off. I made a button, assigned a macro to it and tested it. When I press the button the macro executes to turn the clamp on, but the green bar going down the side of the button does not change state (It remains gray). When I press the button again the same macro runs and the green bar remains off. I would like to push the button and turn on the green bar and execute the macro (m20026). I would like to press the button again and have the green bar go off and a second macro (m20027) run, turning off the clamp. It looks like the Spindle clockwise button works this way, and I would like my button to work the same.

I should have started out by saying I am not a programmer and do NOT play one on tv. I would greatly appreciate and help. Thanks!
ADuarte
 
Posts: 6
Joined: Mon May 20, 2019 4:50 pm

Re: New Button Help

Postby cncdrive » Thu Aug 12, 2021 11:37 pm

cncdrive
Site Admin
 
Posts: 4695
Joined: Tue Aug 12, 2014 11:17 pm


Return to Custom Screensets

Who is online

Users browsing this forum: No registered users and 7 guests