Page 1 of 1

Helps for 4th axis

PostPosted: Sat Dec 09, 2023 5:28 pm
by camivic
Hi everyone, the topic has almost certainly been discussed in the forum, but after some research I gave up!!!
I would like to know what is the correct procedure for working with the 4th axis on UCNC and FUSION 360.
Thank you all.

Re: Helps for 4th axis

PostPosted: Sun Dec 10, 2023 7:53 pm
by camivic
I managed to find some indications, but I have a small doubt: for the 4th axis I'm using a motor/controller with a 100CPR encoder.
Is it right to enter the value of 3.6 in the "Step per unit" setting and flag "Axis is Rotary"?