Helps for 4th axis

Post anything you want to discuss with others about the software.

Helps for 4th axis

Postby camivic » Sat Dec 09, 2023 5:28 pm

Hi everyone, the topic has almost certainly been discussed in the forum, but after some research I gave up!!!
I would like to know what is the correct procedure for working with the 4th axis on UCNC and FUSION 360.
Thank you all.
camivic
 
Posts: 26
Joined: Thu Dec 08, 2016 10:32 pm

Re: Helps for 4th axis

Postby camivic » Sun Dec 10, 2023 7:53 pm

I managed to find some indications, but I have a small doubt: for the 4th axis I'm using a motor/controller with a 100CPR encoder.
Is it right to enter the value of 3.6 in the "Step per unit" setting and flag "Axis is Rotary"?
camivic
 
Posts: 26
Joined: Thu Dec 08, 2016 10:32 pm


Return to General discussion about the UCCNC software

Who is online

Users browsing this forum: No registered users and 48 guests