UB1 AO2 (analog out 2) address
![Post Post](./styles/prosilver/imageset/icon_post_target.gif)
Hi all
My selfmade machine kept on stopping when using the laser and when probing. So I'm about to exchange the MK6-V-II for a UC300ETH on a UB1 and switch from Mach3 to UCCNC.
I’ve figured out how to wire the inverter, sensors, drives etc. But don't know where to get a PWM-Signal for the laser.
According to the user-manual of the UB1, the board has two analog outputs. And if I understand correctly, both can provide a PWM signal.
Here's an printscreen of the manual https://drive.google.com/file/d/18w9HiCQHFZq26sZAZbcKvo0OblD9YPOz/view?usp=sharing
Wow can I address the analog output 2? What are PIN and PORT of AO2?
My selfmade machine kept on stopping when using the laser and when probing. So I'm about to exchange the MK6-V-II for a UC300ETH on a UB1 and switch from Mach3 to UCCNC.
I’ve figured out how to wire the inverter, sensors, drives etc. But don't know where to get a PWM-Signal for the laser.
According to the user-manual of the UB1, the board has two analog outputs. And if I understand correctly, both can provide a PWM signal.
Here's an printscreen of the manual https://drive.google.com/file/d/18w9HiCQHFZq26sZAZbcKvo0OblD9YPOz/view?usp=sharing
Wow can I address the analog output 2? What are PIN and PORT of AO2?