M31

[naijin]

Hi there, I am using this M31 macro, I press the probe button a screen comes up asking for material height, press enter, touch the probe to the tool and it starts to probe for tool height, I don't know much about editing or creating macros, but I do have a question: is it possible to omit or edit out the steps where the material height is asked for and to touch the tool before it starts to probe, what I would like is like what ger21 had in his 2017 screen set, where you pushed the probe button, the tool would travel down at slow speed, touch the plate retract a little bit and do a second probe and then retract, and that was it, I have attached my M31 file, if some one would be so good to have a look at it and advise me on how to edit it or up date it.
Any advise or assistance is always greatly appreciated.

Cheers
Nick

[eabrust]

This macro did what you're explaining (simple/no messages): http://www.forum.cncdrive.com/viewtopic.php?f=2&t=2841#p21796

regards
Eric

[naijin]

Thanks again Eric, I thought I have already asked the question before, but all was lost on the old PC after fatal hard disc crash, and I forgotten all about it until two days ago.
Cheers
Nick