G31 with more than one axis word

Here is where you can request new features or special features.

Re: G31 with more than one axis word

Postby cncdrive » Sun Jan 13, 2019 2:55 am

Yes, you need to do angle function calculation to get the tool radius offset if there is a combined XY probing.
Yes, the controller has to tell you the movement direction when the touch happened if the movement is an arc so then you can calculate the offset using angle function or the controller has to do the calculation for you. :)

I also see some complications about probing parts like on the video is that you need to know the part shape approximately to do the probing with somekind of strategy.
cncdrive
Site Admin
 
Posts: 2643
Joined: Tue Aug 12, 2014 11:17 pm

Re: G31 with more than one axis word

Postby eabrust » Mon Jan 14, 2019 1:07 am

Thanks Balazs,

Do you have any input on if there are future plans to enable combined XY probing (straight G31 linear) in UCCNC?

regards,
Eric Brust
eabrust
 
Posts: 45
Joined: Fri Sep 16, 2016 2:32 am

Previous

Return to Feature Request

Who is online

Users browsing this forum: No registered users and 4 guests