UC400Eth does not connect

Forum for Discussing Mach3/4 related issues

UC400Eth does not connect

Postby dmauch » Tue Oct 15, 2019 5:31 pm

I have my UC400 working fine on my win 10 laptop. But i want to use it on one of my XP pc's. I have followed the instruction manual and while the IP4 properties are set up as 10.10.10.11 and the gateway is 255.255.255.0 and I have the plugin installed in the plugin directory of mach3 when I start mach 3 I get an error that the UC400 is not found. When I click on config plugins it says my firmware is up to date. I have tried using the patch cable and a straight thru ethernet cable. In network and sharing when I unplug the cable the connection goes away. When I re-plug it in the connection is restored. I have run the uc utility. It recognized the uc400 and has the serial number. When I click on save the settings it saves. When I go back and run the utility again and click on test the connection I get the error IP and network settings OK. Connection Error! I also used the ucxxsetup,exe file and deselected everything except for the UC400 and it shows that the setup worked with no problem. Any help would be appreciated.
Dan Mauch
dmauch
 
Posts: 3
Joined: Sun Sep 04, 2016 4:57 pm

Re: UC400Eth does not connect

Postby dmauch » Tue Oct 15, 2019 8:06 pm

I also did the cmd line ipconfig and the response was correct. Similarly I pinged 10.10.10.11 and 4 packets were send and received.
dmauch
 
Posts: 3
Joined: Sun Sep 04, 2016 4:57 pm

Re: UC400Eth does not connect

Postby dezsoe » Tue Oct 15, 2019 8:38 pm

What are the IP settings of your PC?
dezsoe
 
Posts: 932
Joined: Sun Mar 12, 2017 4:41 pm
Location: Csörög, Hungary

Re: UC400Eth does not connect

Postby dmauch » Wed Oct 16, 2019 4:42 pm

10.10.10.11 and 255.255.255.0
dmauch
 
Posts: 3
Joined: Sun Sep 04, 2016 4:57 pm

Re: UC400Eth does not connect

Postby ger21 » Wed Oct 16, 2019 5:12 pm

I have followed the instruction manual and while the IP4 properties are set up as 10.10.10.11


The manual says to use 10.10.10.10.
Gerry
UCCNC 2017 Screenset - http://www.thecncwoodworker.com/2017.html
ger21
 
Posts: 1669
Joined: Sat Sep 03, 2016 2:17 am

Re: UC400Eth does not connect

Postby cncdrive » Wed Oct 16, 2019 7:57 pm

Gerry is right.
If you using the default IP settings in the UC400ETH (means you did not change the IP of the UC400ETH) then the computer IPv4 setting you described is wrong, because it has to be 10.10.10.10 and not 10.10.10.11, because the IP of the UC400ETH is 10.10.10.11 and so then if the computer has the same IP is an IP conflict o nthe network. And when you ping-ing the 10.10.10.11 now you ping-ing the computer network card and not the UC400ETH.
cncdrive
Site Admin
 
Posts: 3141
Joined: Tue Aug 12, 2014 11:17 pm


Return to Mach3/4 Discussions

Who is online

Users browsing this forum: No registered users and 0 guests

cron