First off many thanks to all for helping me get this far after ill health problems ...
OK after playing all day setting up the calibration ( that took some working out ) and movement in the right direction ...
I'm at my head banging bit again
( see ill health of Brain Haemorrhage so got to remember not to stress out ..yea right wrong hobby I picked ...LOL )
did all the design / cutting of lines in Art-cam and works a bloody treat .. And again all self taught over the months learning playing etc and using the SIMULATION mode .. bloody brilliant is this ..any way...
However I'm getting confused could be my age (early 60's) of the Bed movement ?
if you think of it as the bed moving arrow up ...it moves up ...and down is down .. however this goes in the opposite direction on the Y JOG BUTTONS only
Z & X movement on the jog buttons is fine up is up left is left etc
and before you say it ...I'm not swooping any wires or configuration of reverse setup as its working a treat...LOL
So my question is
just on the JOG buttons on the screen I need to reverse them ..is this task at all possible ?
load in a different Jpeg screen and re-set it ?
seen some thing about this but way over my head at the moment