I bought a UC100 USB motion controller and trying to figure out how it works ...
Only to find out I never got the info off the company I bought it off now there gone ...BUST
any help much appreciated
Gary
cncdrive wrote:If it is a UC100 then we can help you. If not then we can't because the fake devices are chinese controllers, they have nothing to do with the UC100.
If you will take a photo of the device by the sides and post it here then we can tell it if it is a UC100 or if it is a chinese fake controller.
Gazza wrote:I bought a UC100 USB motion controller and trying to figure out how it works ...
Robertspark wrote:Gazza wrote:I bought a UC100 USB motion controller and trying to figure out how it works ...
What exactly do you want to know??
WANT TO SWITCH IT ON AND RUN IT AS ITS IN DEMO MODE UCCNC
All the product info is listed here
http://cncdrive.com/UC100.html
YEP IT SURE IS
Are you using it with UCCNC
YES
(i.e. do you have a UCCNC licence for it)
NO LOST IT ON OLD PC THAT WAS THROWN OUT
UCCNC can be downloaded here (stable release)
http://cncdrive.com/UCCNC.html
YES I HAVE THIS AND IT RUNS IN DEMO MODE
When installed, all the documentation is located within the C:\uccnc\documentation folder
YES IT SURE IS
Or are you using it with Mach3?
NO
Or Mach4?
NO
Do you have a breakout board you are intending to use it with? If so which one?
MACHINE IS BUILT WIRED UP AND READY TO USE
Or Mach4?
NO
Do you have a breakout board you are intending to use it with? If so which one?
Return to Ask a question from support here
Users browsing this forum: No registered users and 21 guests