Ok I know this is probably something that has been asked and I have seen some responses on the forum but still a little unclear. I am using a uc400eth with uccnc and just want to make sure that I have the kernel frequency set right. Just not sure how to calculate this as some examples I have are with mm. I am using imperial. Any way my steps per inch are 10,162.77772. This even seems high. I have built a couple of machines in the past but always left mach at 25. This is a machine that I bought that had a handheld controller that worked ok but I did not feel I had great control with it. Any way I left the yako drives with the settings it had but not sure if this should be turned down or if there is a great advantage as I do woodwork for instruments and not metal machine work.
Thanks