by foxfly » Sat Mar 09, 2019 1:25 pm
I have mach3 version 3.043_2018 with windows 10 and uc300eth with two UCBB dual port breakout boards. The probe is connected normally open to pin 15 and gnd of port three, the first measurement is always wrong 6/10 after it is correct. I tried to change the probing speed, the macro, the version of mach3 but the problem remains,
when I put a capacitor between pin 15 and gnd the error of the first measurement is smaller 4/10. The whole electrical part of the milling machine is ok. some idea?