I've managed to work my way around editing a screenset, having been using UCCNC for only a few days. At first I thought it was far more complicated than Mach3 (Machscreen editor) but I'm getting there, slowly.
I wanted to mimic the original Mach3 setup with the 24" touchscreen, set to portrait mode. There is a blank area at the bottom (not shown on the attached image) to allow for an on-screen keyboard.
My next challenge is to figure out how to modify and setup the tool macros for the 8 position tool-changer!
New Touchscreen screenset
7 posts
• Page 1 of 1
Re: New Touchscreen screenset
by eMTea » Tue Jul 12, 2022 11:28 pm
Very nice! Interrested in sharing it?
- eMTea
- Posts: 24
- Joined: Sun Jun 26, 2022 6:19 pm
Re: New Touchscreen screenset
by krsykes23 » Thu Jul 21, 2022 12:52 pm
I could consider sharing it but I'll need to tidy it up before I do. I'm pretty new to UCCNC and some of the other pages (tabs) are somewhat messy.
I'll let you know.
I'll let you know.
- krsykes23
- Posts: 39
- Joined: Wed Apr 27, 2022 9:29 am
Re: New Touchscreen screenset
by hacker77 » Sat Sep 03, 2022 12:31 am
Any idea when you might release this Screenset to the community or forsale?
- hacker77
- Posts: 6
- Joined: Mon Aug 22, 2022 10:38 pm
Re: New Touchscreen screenset
by ian8555 » Tue Dec 27, 2022 9:15 pm
Any news on this being available?
It looks to be just what I am looking for.
It looks to be just what I am looking for.
- ian8555
- Posts: 3
- Joined: Tue Feb 22, 2022 1:38 pm
7 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest