How to permanently save a textfield?

[silverdog]

Hi,
I would like to add some textfields where I want to store the offset of the cross laser led from the center of the mill.
Actually, the code works properly, but the values are lost every time the software is restarted even if Apply and save buttons are used. I would like to save the offsets like any of the textfields used for the motor settings.
Any solutions?

[ger21]

Values in User Textfields are stored in the Profile when UCCNC closes.
You can use the Constructor macro to load the values when UCCNC starts.

[silverdog]

Thank you very much, it works!