Page 1 of 1

Is it possible?

PostPosted: Thu Apr 11, 2019 7:21 pm
by laki
Hello
I am trying to make a new screen set so I have a question about probing the function. Software ver 2109.
I'd like to rearrange the existing probing tab and add a few layers to it. Also, I would set Probing Tab (layer 26) so that his parent tab is layer 1. Will the probing plugin work if I do this?
Probe Tab should look like this with additional layers.

probe.jpg

Link to video
https://www.youtube.com/watch?v=4ly58VOYsEs

Re: Is it possible?

PostPosted: Thu Apr 11, 2019 7:25 pm
by ger21
It shouldn't matter what layers you use, as long as the button numbers are correct.

Re: Is it possible?

PostPosted: Thu Apr 11, 2019 7:29 pm
by laki
Thank you, Gerry

Re: Is it possible?

PostPosted: Fri Apr 12, 2019 5:48 am
by thegreatwaldo
Hi Laki

Nice screenset.
cheers
Andrew

Re: Is it possible?

PostPosted: Fri Apr 12, 2019 6:51 am
by dezsoe
Well, it should not matter, but it does. :)

If the Probe layer is selected then the probing plugin changes the active layer to that layer where the selected mode can be found. So, when you select the probe layer then that page will be displayed where the selected mode can be found. I have to think about how to turn it off or automate.

@laki, I send you a PM.

Re: Is it possible?

PostPosted: Fri Apr 12, 2019 7:55 am
by laki
Thanks Andrew
Dezsoe, I sent you mail to support at cncdrive dot com.