Milling core holes in the clamping plate of my milling machine
Software: UCCNC Ver. 1.2113, Screen from Laki (with own adjustments and changes). Video on YouTube:
Peter
Re: Milling core holes
Posted: Wed Sep 08, 2021 6:52 am
by cncdrive
Video is not showing.
Re: Milling core holes
Posted: Wed Sep 08, 2021 12:13 pm
by MikeM
I can see the video
Re: Milling core holes
Posted: Thu Sep 09, 2021 8:22 am
by cncdrive
Interestingly the video does not show on my computer but it shows and plays fine on my smart TV. Anyways, could you please post the link just to make sure others can view it...
Re: Milling core holes
Posted: Fri Sep 10, 2021 9:16 am
by CADdy
Hi,
when I click on the link above, the video plays normally. Here again is the link to youtube: https://youtu.be/uUTC9nRJwiY
I hope, it works
Peter
Re: Milling core holes
Posted: Fri Sep 10, 2021 11:13 am
by spillage
Thank you… the link works perfectly.
Re: Milling core holes
Posted: Sat Sep 11, 2021 4:09 am
by ger21
Very strange.
I could see the video before, but today I can't? wtf??
Re: Milling core holes
Posted: Sat Sep 11, 2021 6:34 am
by CADdy
ger21 wrote:Very strange.
I could see the video before, but today I can't? wtf??
??? The YouTube-Link posted three above works.
Peter
Re: Milling core holes
Posted: Sat Sep 11, 2021 11:17 am
by ger21
I know the link works, but two days ago I could see the video in the first post, and now it's just a blank white square.
Re: Milling core holes
Posted: Sat Sep 11, 2021 3:13 pm
by tau
ger21 wrote:...and now it's just a blank white square.
Posted: Wed Sep 08, 2021 4:19 am
