Z axis not keeping the calibration value

[cncdrive]

It's also possible that you have no rights to write to the profile file, I mean that the user account does not have that right.
Or there is write protection on the UCCNC folder or on the profile file or on both.
You can easily test this with changing some values and Apply and Save the settings and close the UCCNC and open it up again and see if the changes were saved or not.

[QuebecCNC]

What type of stepper driver are you using? What is the lead screw pitch?

Stepper driver is a Leadshine mx3660. I am using belt drive.

[Koen Vissers]

Hi

I had the same problem but the x axis. No always but sometimes it chage the setting to 0.001.
When I re calbrate to 400 it works well but displays 0.001

I can post a print screen when home.

Grtz Koen

[Koen Vissers]

Hi all


I tried today a full reset off the program but the same result.
First remove the installed one , new start up on windows install again but same problem
When I calibrate my x axis i become 400 step/rev when push apply and save it goes from 400 to 0.0001.
I just downloaded a new exe from the UCCNC website. So its a clean one.

Hope someone can help.

Thx Koen

[cncdrive]

You have to press the ENTER keyboard key in the textfields to validate your text inputs if the Configuration/Appearance/Validate textfields with enter key only option is checked (default).
If you have that option checked and if you input a text, but do not press the ENTER keyboard key then the textfield parameter will not change and if you then pressing the apply settings then it will revert back to what value it had.

[QuebecCNC]

I always press enter