UC300-5LPT USB drivers wont install win 10 64

[gabi68]

That is not available. Is that expensive to make the dirvers signed with Win 10 and end this saga? NEXT ...

[thegreatwaldo]

Could the problem be the bios is in legacy mode and not UEFI (https://neosmart.net/wiki/enable-uefi-boot/) ??

Cheers
Andrew

[gabi68]

The laptop is running fine like it is. Too many problems to change it now (GPT, MBR partiton's). The fact is I should not be changing anything in my system to make the software work. I think CNCdrive should tackle this problem properly. What I am facing is only the tip of the aisberg. That being said, what else should I do to make it work?

[cncdrive]

Signing the drivers with Microsoft costs about 8000 Euros, but our original drivers which now do not install are signed by Microsoft and still they do not work.
I think it is very likely that Microsoft messed up something in their latest Windows update is why this is not working now, just like how they did with OpenGL some time ago.
But again, it should work with Secure boot option in the BIOS off and the signature enforcement in Windows off, I mean any drivers should install that way no matter if they are signed at all or not...

[gabi68]

If I buy the ETH version can I replace only the top part (the FGPA), the cable with the proper configuration? It is quite hard to change the controller entirely (lack of space).

[gabi68]

Hellloooo

[A_Camera]

If I buy the ETH version can I replace only the top part (the FGPA), the cable with the proper configuration? It is quite hard to change the controller entirely (lack of space).

I guess the official answer will be yes to this. I have both USB and ETH versions but I really can't see any difference between them other than the FPGA board.

[cncdrive]

Yes, they are the same except that the ETH version must be powered externally via the power screw terminal of the -5LPT motherboard, it cannot be powered like the USB version via the USB cable from the USB port.
The price of the top module is 100 EUR and the price of the bottom module is 25 EUR.
This is because the top part contains all expensive components and it is a 4 layer PCB while the bottom is 2 layers, so the top part is much more expensive.

[gabi68]

Great, how can I order the top part only? I can't see that on your webshop.

[cncdrive]

Please place an order for a UC300ETH-5LPT and when filling the address in your order then put a note about that you only need the top module and then we will threat your order accordingly.