connecting mpg

If you have a question about the software please ask it here.

connecting mpg

Postby Wilx65 » Fri Mar 27, 2020 9:23 am

Hi Im looking for advise on connecting a mpg to my ucbb breakout board
in running uccnc and a uc300eth

my question is where the a anb b wires from the mpg connect to the breakout board

thanks
Wilx65
 
Posts: 2
Joined: Fri Mar 27, 2020 9:18 am

Re: connecting mpg

Postby cncdrive » Fri Mar 27, 2020 11:22 am

You can connect them to any of the inputs of the UCBB, then you just have to configure the MPG pins according to your connections.
cncdrive
Site Admin
 
Posts: 4695
Joined: Tue Aug 12, 2014 11:17 pm

Re: connecting mpg

Postby Wilx65 » Fri Mar 27, 2020 3:30 pm

so do i put them into the negative position on the input pin or the positive?
Wilx65
 
Posts: 2
Joined: Fri Mar 27, 2020 9:18 am


Return to Ask a question from support here

Who is online

Users browsing this forum: No registered users and 28 guests

cron