kig23 wrote:Hi,
i've configured the M7 relay pin (17) and port (1), the Flood/Mist relay outputs enable is checked, but there is no signal on pin17 port1. I've tried with UC100, UC400 and in demo mode and different computers, but nothing. I've tried to execute M7 from MDI, but nothing and in the diagnostics screen the led of I/O monitor for pin17 port1 doesn't change the state. This issue is with version 1.2106. Some advices please. Thanks.
HI,
Thank you for the profile. I've tested the whole table below with your profile on UC100, UC300ETH and UC400ETH:
- Code: Select all
UC100 UC300 UC400 100Demo 300Demo 400Demo
2106 fail(1) OK OK fail(2) OK OK
2107 OK OK OK OK OK OK
(1) The UC100 outputs are shuffled
(2) No reaction on the diag tab
This problem is only with the UC100 and it is already fixed in version 1.2107 which is coming soon. I could not reproduce the error with UC300ETH or UC400ETH.