Settings not saving

If you have a question about the software please ask it here.

Settings not saving

Postby DWhiteR1 » Sun Oct 28, 2018 8:25 am

Hi,
When I try set the Step and Dir ports and pins they go back to zero when I press save.

Please help
Regards,
Dean.
DWhiteR1
 
Posts: 6
Joined: Sun Oct 28, 2018 8:19 am

Re: Settings not saving

Postby cncdrive » Sun Oct 28, 2018 8:31 am

It is because the setting you made is wrong. You trying to attach an input port pin to an output function or an output port pin to an input function.
cncdrive
Site Admin
 
Posts: 2363
Joined: Tue Aug 12, 2014 11:17 pm

Re: Settings not saving

Postby DWhiteR1 » Sun Oct 28, 2018 8:50 am

Hi,
I'm trying to assign pin 2 to step and pin 3 to Dir
Im using a HDBB2 board, on page 5 of the documentation for HDBB2 it says X axis step signal pin = 2 and dir = 3
The HDBB2 board is plugged into port 1 of my UC300ETH.

So I set the port to 1 and the pins to 2 and 3 respectively.
What am I missing? :-(

Regards,
Dean.
DWhiteR1
 
Posts: 6
Joined: Sun Oct 28, 2018 8:19 am

Re: Settings not saving

Postby DWhiteR1 » Sun Oct 28, 2018 9:01 am

OK, Got it,

I saw on diagnostics screen and changet to port 2

Its working now.
sorry, my first time using UC300 and UCCNC

Thank you.

Regards,
Dean
DWhiteR1
 
Posts: 6
Joined: Sun Oct 28, 2018 8:19 am

Re: Settings not saving

Postby cncdrive » Sun Oct 28, 2018 9:31 am

No problem.

On port#1 pins 2. to 9. are inputs and not outputs, but I see you already figured it out. :)
cncdrive
Site Admin
 
Posts: 2363
Joined: Tue Aug 12, 2014 11:17 pm


Return to Ask a question from support here

Who is online

Users browsing this forum: No registered users and 7 guests

cron