Hi. A good while back I bought a UC300ETH with a UB1 from CNCroom.com but a home move delayed the completion of my machine and I never got around to unpacking it until now. I'm now starting to build the electronics for the machine so I unpacked the UC300 downloaded and installed the software and copied the license file into the UCCNC directory. Hooked up power and ethernet waited for a steady green on the UC300 then started the software, but it will only start in demo mode, my UC300ETH-UB1 isn't listed.
I ran the UCxxx_utility and it finds the card OK and the serial number matches the serial number on the license any ideas why the UCCNC software isn't detecting the card?