UCCNC Closing

If you have a question about the software please ask it here.

UCCNC Closing

Postby valhallaCNC » Sun Jul 07, 2024 2:27 pm

Is there a reason UCCNC has to close when there is a Ethernet loss to the controller. I recently was experiencing intermittent Ethernet problems, very brief losses. With UCCNC closing it just seemed like the program was crashing. It was a hard problem to diagnose because every restart Ethernet was fine. A Estop with a Communication error message box would be a easy indicator of the problem.
valhallaCNC
 
Posts: 69
Joined: Wed Jun 30, 2021 8:04 pm

Re: UCCNC Closing

Postby cncdrive » Sun Jul 07, 2024 7:49 pm

UCCNC is built like that, if it looses the connection with the motion controller then it closes the application after asking to save datas.
cncdrive
Site Admin
 
Posts: 4779
Joined: Tue Aug 12, 2014 11:17 pm

Re: UCCNC Closing

Postby valhallaCNC » Sun Jul 07, 2024 8:10 pm

Thanks for the reply,
If the machine has been homed with nothing else done . As soon as Ethernet link is lost, it closes without a prompt. Unless you're looking for a problem just gives the impression of a crash.
valhallaCNC
 
Posts: 69
Joined: Wed Jun 30, 2021 8:04 pm


Return to Ask a question from support here

Who is online

Users browsing this forum: No registered users and 4 guests