Pulley settings again

If you have a question about the software please ask it here.

Pulley settings again

Postby CADdy » Thu Aug 04, 2022 12:10 pm

Hi all,

I need a little help. I am having trouble with the pulley settings. These are my settings:

Pulley Settings1.png
Pulley Settings1.png (7.13 KiB) Viewed 107 times

Pulley Settings2.png
Pulley Settings2.png (21.21 KiB) Viewed 107 times


I put the M215 P1 command at the very beginning of the milling file:

Code: Select all
(20220723-1)
(T11  D=6. CR=0. - ZMIN=-14.9 - Schaftfraser)
(T25  D=5. CR=0. TAPER=90deg - ZMIN=-2.5 - Konische Senkung)
(T27  D=13. CR=1. - ZMIN=-1. - Planfraser)
G90
G0 G53 Z0.

(Planen1)
T27 M6
(Wendeplatte)
M215 P1
S8000 M3
G64 P0.01
G54
G43 H27
M8
.....


A "M3 S8000" should then drive the spindle motor with approx. 13722 rpm. But this does not work. The motor turns with 8000 rpm, not the spindle. If I enter the necessary commands by hand, it sometimes works, sometimes not.

Am I doing anything wrong?

Peter
CADdy
 
Posts: 115
Joined: Sun Sep 17, 2017 2:26 pm

Re: Pulley settings again

Postby CADdy » Thu Aug 04, 2022 8:43 pm

UCCNC-version is 1.2113
CADdy
 
Posts: 115
Joined: Sun Sep 17, 2017 2:26 pm


Return to Ask a question from support here

Who is online

Users browsing this forum: No registered users and 2 guests

cron