Estop problem with upgrade

If you have a question about the software please ask it here.

Estop problem with upgrade

Postby markcadcam » Wed Jun 12, 2019 12:44 pm

This morning I upgraded my software from 1.2046 to 1.2110. Now my Estop will only activate when the switch is normally closed, even if I change the setting 'Active low'. The setting 'Active low' makes no difference checked or unchecked. I move the Estop to another pin and it does the same thing. Was there a change made in version 1.2110 for the Estop to activate only when a switch is closed?

Thanks
Mark
markcadcam
 
Posts: 46
Joined: Thu Apr 13, 2017 1:52 pm

Re: Estop problem with upgrade

Postby markcadcam » Wed Jun 12, 2019 1:38 pm

A little more information. I'm using a UC300 (USB) controller with a 5LPT board. The Diagnostics shows everything is working properly.
markcadcam
 
Posts: 46
Joined: Thu Apr 13, 2017 1:52 pm

Re: Estop problem with upgrade

Postby markcadcam » Thu Jun 13, 2019 1:45 am

Can I get some help please?
markcadcam
 
Posts: 46
Joined: Thu Apr 13, 2017 1:52 pm


Return to Ask a question from support here

Who is online

Users browsing this forum: No registered users and 5 guests