M5 takes very long time to execute spindle off - 1.2116
1 post
• Page 1 of 1
M5 takes very long time to execute spindle off - 1.2116
by hobycreator » Sun May 26, 2024 6:26 pm
M3 starts the spindle instantly, but M5 or the e-stop takes 10 seconds or more to initiate the stop signal through RS485, rolling back to 1.2115 solves issue.
- hobycreator
- Posts: 3
- Joined: Wed May 11, 2022 6:06 am
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 11 guests