constant startup tone (reset.wav)

If you think you've found a bug post it here.

Re: constant startup tone (reset.wav)

Postby stirling » Thu Aug 16, 2018 5:09 pm

cncdrive wrote:I did not take it as critism, I just thought it is funny, because you said "simple graphics" while the graphics algorithms of the UCCNC is very complex.

To be fair I said "relatively simple graphics". I'm comparing what I see on (say) modern 3D games screens with what I see on the screen of a motion controller.

Anyway, all it is, is that some of my DTHC customers ask me when I'm going to support UCCNC. To answer that I needed to experiment with it and ask questions when I hit issues. I've been diddling with Mach3 for over a decade but I've only been diddling with UCCNC for a couple of weeks so if some of my questions sound dumb I apologize. I now know that when they ask "will it run on my Mach3 XP 'brick', I can advise them accordingly and they can make their decision.

Meanwhile I'll look at getting a more up to date PC and carry on experimenting from there.

Thanks again
UC300ETH_5LPT
Razordance DTHC
http://www.razordance.co.uk/THC.htm
stirling
 
Posts: 32
Joined: Mon Jul 23, 2018 12:54 pm

Re: constant startup tone (reset.wav)

Postby ger21 » Thu Aug 16, 2018 5:37 pm

New small PC's like this can work pretty well. I don't have any personal experience, but I've seen others using them.
https://www.amazon.com/ACEPC-Processor- ... ds=mini+pc
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
ger21
 
Posts: 2663
Joined: Sat Sep 03, 2016 2:17 am

Re: constant startup tone (reset.wav)

Postby cncdrive » Thu Aug 16, 2018 5:43 pm

cncdrive
Site Admin
 
Posts: 4695
Joined: Tue Aug 12, 2014 11:17 pm

Re: constant startup tone (reset.wav)

Postby stirling » Sat Aug 18, 2018 10:37 am

OK, Thanks
UC300ETH_5LPT
Razordance DTHC
http://www.razordance.co.uk/THC.htm
stirling
 
Posts: 32
Joined: Mon Jul 23, 2018 12:54 pm

Previous

Return to Report a bug

Who is online

Users browsing this forum: No registered users and 7 guests