Strange moves in all axis

If you think you've found a bug post it here.

Strange moves in all axis

Postby Vmax549 » Tue May 08, 2018 2:00 pm

This is a piece of code that show starnge moves in all axis when it runs. I have stripped out all teh unneccesary code and it still fails every time it is run as tested.

Enable all axis xyzabc

Home all

Run M20965

When it get down to teh last axis move( G53 B0 ) ALL axis will move instead of just B only.

This ONLY happens after a Home all. After it cycles through one time and does teh errant moves it seems to run correctly after that as long as you do not home all again. IF you run it right after a home all it errors again.
Attachments
M20965.txt
(915 Bytes) Downloaded 72 times
Vmax549
 
Posts: 1274
Joined: Sun Nov 22, 2015 3:25 am
Location: USA

Re: Starnge moves in all axis

Postby dezsoe » Tue May 08, 2018 2:04 pm

Which UCCNC version(s) did you try?
dezsoe
 
Posts: 531
Joined: Sun Mar 12, 2017 4:41 pm
Location: Csörög, Hungary

Re: Strange moves in all axis

Postby Vmax549 » Tue May 08, 2018 3:18 pm

2047 and 2104 , uc300usb and uc300eth

(;-)TP
Vmax549
 
Posts: 1274
Joined: Sun Nov 22, 2015 3:25 am
Location: USA

Re: Strange moves in all axis

Postby dezsoe » Tue May 08, 2018 3:55 pm

Thanks. :)
dezsoe
 
Posts: 531
Joined: Sun Mar 12, 2017 4:41 pm
Location: Csörög, Hungary


Return to Report a bug

Who is online

Users browsing this forum: No registered users and 4 guests