UC300ETH Conection lost

[MarcoGaspar]

Hello,

I have UC300ETH directly connected to the PC with a crossover RJ45 cable but if i connect a wireless usb UCCNC shows lost connection and closes and have to open again.

[cncdrive]

Do not connect the UC300ETH via wireless, it requires wired ethernet connection for reliable operation.

[MarcoGaspar]

Hello,

I have UC300ETH directly connected to the PC with a crossover RJ45 cable but if i connect a wireless usb UCCNC shows lost connection and closes and have to open again.

Has i say i have directly connected.. i use wireless usb pen to connect to internet.

[cncdrive]

Then the wireless USB pen probably overloads your computer.

[MarcoGaspar]

It's a I3 with 32gb ddr4 ram

[cncdrive]

Try this registry key modification to make your PC network card latency higher:

Type command line: regedit
Hkeylocalmachine\SOFTWARE\Microsoft\Windows NT\CurrentVersion\Multimedia\SystemProfile"; ValueType: dword; Name: "NetworkThrottlingIndex"; Value: 0xFFFFFFFF;