LOSS OF G92 OFFSET AFTER POWER OFF

If you think you've found a bug post it here.

LOSS OF G92 OFFSET AFTER POWER OFF

Postby sigraph » Fri May 03, 2019 11:16 pm

when setting a work coordinate (corner pickup) with an edge finder I input the x and y values into the work offset column (G54) and add or subtract half the edge finder in the G92 column.
I'm using g92 like a common offset on a Fanuc controller.
After turning machine off and returning "later" G92 offset has reset to Zero.
Work coordinates are still good.
If I ran another toolpath without checking I'd be off by half the diameter of the edgefinder.
Why does it reset to zero?
sigraph
 
Posts: 6
Joined: Tue Aug 29, 2017 2:25 pm

Re: LOSS OF G92 OFFSET AFTER POWER OFF

Postby cncdrive » Fri May 03, 2019 11:24 pm

It is not a bug. G92 is temporary offset, it is valid for the running session only and clears on power down.
If you need those permanent then you could write a macro to save the temporary offsets into the profile file on power down (M99999) and you could load and apply them to the DROs on power up (M99998).
cncdrive
Site Admin
 
Posts: 2766
Joined: Tue Aug 12, 2014 11:17 pm


Return to Report a bug

Who is online

Users browsing this forum: No registered users and 5 guests