Run From Here GLITCH

If you think you've found a bug post it here.

Run From Here GLITCH

Postby Vmax549 » Sat Oct 06, 2018 5:32 pm

There appears to be a glitch in the RFH function. When it reads teh Gcode file for setup it does NOT reset teh G90/91 value to the value called for in the Gcode program.

For instance UCCNC is set as G91. And you are doing a RFH in a program that does NOT have any G91 calls it is ALL G90.

When RFH is run it does NOT reset teh G90 that is called for in teh program before it Starts teh RFH motion. That causes a crash as teh toolpath is now incorrect.

Also in each section of teh RFH process could you PLEASE have it send a status message to the operator
to "Press CycleStart to Continue" so teh operator knows what is require to continue.

(;-) TP
Vmax549
 
Posts: 1297
Joined: Sun Nov 22, 2015 3:25 am
Location: USA

Return to Report a bug

Who is online

Users browsing this forum: No registered users and 7 guests