Page 1 of 2

Using Mach3 with UC300eth

PostPosted: Sat Sep 21, 2019 1:44 am
by Vmax549
Using teh UC300eth with mach3 and the UCCNC plugin DOES the THC function work ?? Or was it not included in teh plugin?

(;-) TP

Re: Using Mach3 with UC300eth

PostPosted: Sat Sep 21, 2019 2:19 am
by cncdrive
Yes.

Re: Using Mach3 with UC300eth

PostPosted: Thu Sep 26, 2019 8:39 am
by stirling
How do you turn THC on?

I've tried doOEMButton with OEM code 123, startTHC and even THCon (which I know doesn't work even with the parallel port)

Thanks

Re: Using Mach3 with UC300eth

PostPosted: Thu Sep 26, 2019 9:46 am
by cncdrive
With the THC button on the screen?! :)
But we have always used the UCCNC and it has an M code to turn the THC on/off.
You will have to ask machsupport about how to do that in mach3.

Re: Using Mach3 with UC300eth

PostPosted: Thu Sep 26, 2019 10:34 am
by stirling
I hoped it was clear I know how to turn THC on in Mach3. I also hoped it was clear that none of the methods I stated work when using the plugin for the UC300ETH.

I got the plugin from your site so I was hoping you may have some insight into why none of the available methods in Mach3 appear to work.

Re: Using Mach3 with UC300eth

PostPosted: Thu Sep 26, 2019 12:07 pm
by cncdrive
I don't know sorry. It works at us with the THC button.

Re: Using Mach3 with UC300eth

PostPosted: Thu Sep 26, 2019 1:07 pm
by stirling
Which screenset are you using?

Re: Using Mach3 with UC300eth

PostPosted: Thu Sep 26, 2019 2:46 pm
by cncdrive
The default plasma screen.

Re: Using Mach3 with UC300eth

PostPosted: Fri Sep 27, 2019 7:51 am
by stirling
progress - wiped Mach3 - clean install and of plugin. Now working.

Re: Using Mach3 with UC300eth

PostPosted: Mon Sep 30, 2019 5:18 pm
by NikolayUA24
The controller works with version 2.63