Hi,
I have a VistaCNC iMach III P4-S pendant that was working fine in V1.2113, but it is not operating correctly in 1.2116. I've sent a note to them as well, but was wondering if anything has changed in UCCNC that would effect their dll and mess with it working correctly?
Thanks,Bob
VistaCNC P4-S pendant not working in 1.2116
3 posts
• Page 1 of 1
VistaCNC P4-S pendant not working in 1.2116
by bob_mllr » Sat Mar 23, 2024 8:58 pm
- bob_mllr
- Posts: 9
- Joined: Tue Mar 03, 2020 10:25 pm
Re: VistaCNC P4-S pendant not working in 1.2116
by cncdrive » Sat Mar 23, 2024 11:05 pm
What is not working correctly?
- cncdrive
- Site Admin
- Posts: 4727
- Joined: Tue Aug 12, 2014 11:17 pm
Re: VistaCNC P4-S pendant not working in 1.2116
by bob_mllr » Sun Mar 24, 2024 1:09 am
The pendant does not activate correctly - it does not show the axis selection or the coordinates. The jog wheel does not work, or initially jogs a little then stops working. Basically does not work correctly from startup. I can post a video?
Bob
Bob
- bob_mllr
- Posts: 9
- Joined: Tue Mar 03, 2020 10:25 pm
3 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 2 guests