Z Axis brake release

Post anything you want to discuss with others about the software.

Z Axis brake release

Postby CNCChris » Wed Jul 06, 2022 3:45 am

What's the general setup for a z axis break release? Is it setup so it releases when RESET is pushed? It's a 24v brake so is it run through a relay or can one of the outputs handle it? AXBBE
CNCChris
 
Posts: 25
Joined: Fri May 17, 2019 8:20 am

Re: Z Axis brake release

Postby Battwell » Sat Jul 09, 2022 12:25 pm

a brake would be via a relay and seperate 24v supply normally.
relay can be off z enable signal. or better still off brake output of your servo drive.
Uc300eth on router and mill.
UK uccnc powered machine sales. https://cncrouter.uk/atc-cnc-routers.htm
Automateanything/duzzit cnc/mercury cnc
Battwell
 
Posts: 821
Joined: Sun Sep 25, 2016 7:39 pm
Location: South Wales. Uk


Return to General discussion about the UCCNC software

Who is online

Users browsing this forum: No registered users and 20 guests

cron