Doncis wrote:Thanks, I will check later.
I assume that it exclude feed rate only for display purposes. Imagine you want to cut simple slot only with A axis, with set G1 deg/min feed rate, and boom crash with rapid feed..it should always respect G1..
btw I always use G93 for 4axis.
I side with Donics on this.
A feedrate command invoked on a single axis, no matter what X,Y,Z,A,B,C it should be respected and executed, in multi axis moves, whatever the program does, also tricks like not make it a rotary but rollover it a rotary then it obeys:
Common you guys: it is a rotary. Sounds the same as: tell it is a circle then the square can roll.