Page 5 of 5

Re: JIT enable option?

PostPosted: Mon Dec 02, 2019 3:29 pm
by cncdrive
Yes, the error message is a .NET framework error message. The error message is not generated by the UCCNC software, but the .NET framework. It is probably an error in the screenset file.

Unfortunately if you could not make the UCCNC modifications to work then there is very little to no chance that you will have luck with Mach4 and it's scripting language (Lua), because it is much more complicated.
But again, good luck to you, hopefully I will be wrong.

Re: JIT enable option?

PostPosted: Fri Dec 06, 2019 1:27 pm
by Mario Soto
This is very good software and the support is always available. I would recommend it to anyone looking for a cnc controller.

Re: JIT enable option?

PostPosted: Fri Dec 06, 2019 5:51 pm
by eabrust
Mario Soto wrote:This is very good software and the support is always available. I would recommend it to anyone looking for a cnc controller.


I fully agree, UCCNC is very good software with great support! :lol: I thought the statement needed to be clarified a bit. ;)