OK, thanks for the info.
Can you please test again with the attached exe file?
I removed a few things to see if it's still crashing to narrow down where the problem lies.
cncdrive wrote:OK, thanks for the info.
Can you please test again with the attached exe file?
I removed a few things to see if it's still crashing to narrow down where the problem lies.
cncdrive wrote:Thanks.
Again a new exe file attached.
Now please tell me if you get messageboxes with texts 1., 2., 3. and 4. or in which of these do you get?
Also please let me know if the app. still crashes or startsup now?
cncdrive wrote:OK, thank you.
Then non of the things causing the issue which I thought about, but something else.
Again a new exe is attached, I just want to see if it starts or crashes?
The toolpath viewer is fully disabled in this exe, but don't worry about that now.
Return to General discussion about the UCCNC software
Users browsing this forum: No registered users and 7 guests