Tuning and Calibration

Post anything you want to discuss with others about the software.

Tuning and Calibration

Postby Spinweight » Mon Apr 08, 2019 7:48 pm

I would like to finely tune my CNC to be the best that it can be but running into some challenges.
Running UCCNC, UC300ETH, Gecko G320X, Nema 44 servo.
My circles are out of round even though they would be inside a perfect square.
I've tuned my XYZ steps accurately but have only been guessing how to calibrate Velocity, Acceleration and Comp Acceleration.
Do you have any advice for me?
Spinweight
 
Posts: 6
Joined: Thu Jan 17, 2019 7:21 pm

Return to General discussion about the UCCNC software

Who is online

Users browsing this forum: Bing [Bot] and 16 guests