Rotary toolpath view

Post anything you want to discuss with others about the software.

Rotary toolpath view

Postby Haik » Fri Oct 12, 2018 5:08 pm

Currently UCCNC stacks each individual degree (eg- A359, A358, etc.) of a rotary toolpath on a single plane providing a 2D view in a 3D toolpath view.
Is it possible for UCCNC to display a toolpath that is distributed 360 degrees around its (rotary) axis?
See pic...
If so, what would I need to do? Thanks!

Rotary toolpath view
Posts: 27
Joined: Fri Sep 08, 2017 6:01 pm

Re: Rotary toolpath view

Postby cncdrive » Fri Oct 12, 2018 6:46 pm

No it is currently not possible.
Site Admin
Posts: 2639
Joined: Tue Aug 12, 2014 11:17 pm

Return to General discussion about the UCCNC software

Who is online

Users browsing this forum: No registered users and 1 guest