UC300ETH-UB1 + LINEAR ATC

Post anything you want to discuss with others about the software.

UC300ETH-UB1 + LINEAR ATC

Postby karlo terrazas » Thu May 10, 2018 11:37 pm

I´m really new to UCCNC, so far its been working great.

I Would like to add an ATC to my setup, but i dont really know where to start, currently i´m using the UC300 WITH the UB1 breakout and the Ger UCCNC 2017 Screenset.

The UB1 has plenty I/O pins and the spindle is the HSD 915A.


Any help you can give??? where do i need to start?

Thanks in advance!
karlo terrazas
 
Posts: 7
Joined: Thu May 10, 2018 11:31 pm

Re: UC300ETH-UB1 + LINEAR ATC

Postby cncdrive » Fri May 11, 2018 4:08 am

The M6 macro file which installs with the the UCCNC is an example linear toolchanger macro.
I advice you to start with checking that macro code first and probably it could work for you.
cncdrive
Site Admin
 
Posts: 4695
Joined: Tue Aug 12, 2014 11:17 pm


Return to General discussion about the UCCNC software

Who is online

Users browsing this forum: No registered users and 18 guests