Hello,
i setup my uc300eth wit uccnc.
I connect uc300 with hdbb2 and i want to use Port1 from uc300 but when i set on x-axis port 1 i cant save this setting ?? When i use port 2 it works fine.
Second question what number to write on turn per unit in A axis (4th axis with chuck) there is no ball screw i only have nema 23 200step + chuck with gearbox 1:100 na i set driver to 1/2 step.
How to connect to hdbb2 relay to start mist. I have 5V/230V relay for my air valve.
The last question i have vfd when i can set up 0-5V (VR) to control how to set this using hdbb2. Do i need some relay to start/stop spindle??
Regards Kamil from Poland