uccnc and raspberry

Post anything you want to discuss with others about the software.

uccnc and raspberry

Postby alfre » Sun Jul 08, 2018 3:33 pm

Hi guy!! A bizarre question: Can Uccnc software run on Raspberry PI 3 board with windows 10 IoT? thanx.
alfre
 
Posts: 31
Joined: Thu Dec 15, 2016 11:33 am
Location: Italy

Re: uccnc and raspberry

Postby ger21 » Sun Jul 08, 2018 5:11 pm

No, it only works with CNC Drive motion controllers.
Gerry
UCCNC 2017 Screenset - http://www.thecncwoodworker.com/2017.html
ger21
 
Posts: 994
Joined: Sat Sep 03, 2016 2:17 am

Re: uccnc and raspberry

Postby alfre » Sun Jul 08, 2018 5:26 pm

Excuse me I explained wrong: I meant to use raspberry as a PC and load in UCCNC as software controller. After connecting via Ethernet the Uc400eth. I hope it's more understandable. Thanks again
alfre
 
Posts: 31
Joined: Thu Dec 15, 2016 11:33 am
Location: Italy

Re: uccnc and raspberry

Postby kawarider » Sun Jul 08, 2018 5:43 pm

That would be very nice!
kawarider
 
Posts: 4
Joined: Sun Jun 17, 2018 10:38 am

Re: uccnc and raspberry

Postby cncdrive » Sun Jul 08, 2018 5:49 pm

We did not try that, but I think that it will not work, because the UCCNC is using OpenGL hardware accelerated graphics and it requires a relatively powerful GPU.
I don't think the Raspberry PI has that, but more powerful mini PCs work fine, e.g.: http://shop.cncdrive.com/index.php?categoryID=137
cncdrive
Site Admin
 
Posts: 2000
Joined: Tue Aug 12, 2014 11:17 pm

Re: uccnc and raspberry

Postby ger21 » Sun Jul 08, 2018 5:55 pm

Sorry, I didn't read it properly
Gerry
UCCNC 2017 Screenset - http://www.thecncwoodworker.com/2017.html
ger21
 
Posts: 994
Joined: Sat Sep 03, 2016 2:17 am

Re: uccnc and raspberry

Postby limited660 » Tue Jul 10, 2018 7:26 pm

I've tried installing Windows 10 on the Pi per a Reddit post and I was never able to get to the desktop and I've also tried Exagear on it with no luck.
limited660
 
Posts: 8
Joined: Mon Jun 25, 2018 1:13 pm


Return to General discussion about the UCCNC software

Who is online

Users browsing this forum: No registered users and 3 guests