forum.cncdrive.com

My UC300ETH-5LPT motion controller is due to arrive today! Are there pullup resistors on all input pins on the 5LPT?

The reason I ask is my controller uses a simple board that breaks out LPT pins to four drivers with no easy access to unused pins. I would like to wire home and limit switches to some of the 5LPT input pins without having to go through a separate breakout board if that is possible.

Regards,
Ed

Yes, there are pullups on all input pins.

I assumed there was, but thought I better make sure before chasing some sort of weird problem.

Thanks,
Ed