Powering a uc300eth
4 posts
• Page 1 of 1
Powering a uc300eth
by jesus638 » Mon Apr 04, 2022 1:19 am
Can the uc300eth-5lpt be powered by the ucsb generated 5V.
- jesus638
- Posts: 3
- Joined: Mon Mar 28, 2022 1:49 am
Re: Powering a uc300eth
by Dazp1976 » Mon Apr 04, 2022 9:27 am
jesus638 wrote:Can the uc300eth-5lpt be powered by the ucsb generated 5V.
It's likely it won't work properly.
The ports on the 5lpt prob won't 'register' correctly with breakout boards attached to it.
In other words, some circuits won't be completed.
It's designed the way it is for a reason.
Power the uc300 direct first, then use idc26 cable to get 5v to the ucsb via pin26.
- Dazp1976
- Posts: 162
- Joined: Wed Mar 16, 2022 12:57 pm
Re: Powering a uc300eth
by cncdrive » Mon Apr 04, 2022 9:35 am
You should not do that, because it bypasses the isolation of the UCSB breakout board.
You should use separate powersupplies.
You should use separate powersupplies.
- cncdrive
- Site Admin
- Posts: 4741
- Joined: Tue Aug 12, 2014 11:17 pm
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 11 guests