is this your speed controller board?
if not can you provide a link
https://www.google.com/url?sa=t&source= ... L4f7TMn5hG
Robertspark wrote:is this your speed controller board?
if not can you provide a link
https://www.google.com/url?sa=t&source= ... L4f7TMn5hG
cncdrive wrote:Please tell me the following:
With the AXBB-E analog output not connected to anything and measuring the voltage between the analog output and it's ground what voltage are you getting with the jumper on and also with the jumper off, if you setting the PWM max. value to 100% and you programming M3 Sxxx, where the xxx equals the maximum setup spindle speed on the spindle tab page?
cncdrive wrote:Please tell me the following:
With the AXBB-E analog output not connected to anything and measuring the voltage between the analog output and it's ground what voltage are you getting with the jumper on and also with the jumper off, if you setting the PWM max. value to 100% and you programming M3 Sxxx, where the xxx equals the maximum setup spindle speed on the spindle tab page?
Users browsing this forum: No registered users and 9 guests