Page 1 of 1

axbb-e new installation

PostPosted: Sat Jun 15, 2019 1:21 am
by ricky_h
Hi, I've just purchased an AXBB board with UCCNC software.
I have, I believe, a Askpower A131 inverter.
Trying to research the connections, seems like 'gnd to fwd' I just need to switch on via the AXBB 24v 0 & isolated output 02. then the spindle speed is gnd & +10v, which I connect to 5v0 & AO1. I'm a newbie at this, and looking for confirmation please?
Please ignore the existing wiring, this was how i bought the machine

Thanks, in advance

Re: axbb-e new installation

PostPosted: Mon Aug 19, 2019 1:08 am
by Willy
Hye Ricky you had any luck I have the same spindle and would love to get it up and going as well :-)