UCCNC and Arduino

[camivic]

Hi everyone, I programmed an Arduino micro as a USB keyboard, assigning a keyboard character to each pin. Then on UCCNC I configured the hotkeys with the characters transmitted by Arduino, but they don't work. If I try to write in the MDI the characters are received, but the commands are not executed.
Can anyone help me?

Thanks.

[cncdrive]

Try to send an ENTER character after the command text.

[camivic]

Tryed, but nothing!!!

[A_Camera]

Does it work if you are using a real USB keyboard? Perhaps it is a configuration issue.
If you start up Notepad or another text editor, can you see the characters in the editor? Perhaps it's your keyboard emulating firmware has some bugs.

[camivic]

Yes, if I open Notepad or any other application, the keys are recognized correctly. I really don't understand!!!